The ground should be level in order to allow for accurate alignment of the beam. If the adjusting screws are tightened first then loosened they will continue to loosen when the vehicle is in motion and may cause the headlights to become misaligned.
Look trough the visor and look for a horizontal part of the car or two symmetrical points on the car for example.
2010 mazda 6 headlight adjustment screws. Therefore perform the headlight aiming adjustment on only the low beam. How do i adjust the headlights on a 2003 mazda 6. Turn the adjusting screws and adjust the headlight so that the elbow point in the shaded area in the figure.
Mazda6 headlight adjustments tally hi all i am going to france soon with my 2006 mazda6 and i cannot find in the handbook whether i need to fit a headlamp conversion kit or if i can adjust the headlights for driving on the continent. If you look straight downward behind the headlight youll see two phillips head screws look back up at you. My 2014 mazda 6 gt is stock.
Put the hbt in the front of one of the car lights about 20 50 cm. Online shopping for headlight adjusting screws headlight parts accessories from a great selection at automotive store. Will this part resolve that issue or is it just for vehicles that have been lowered.
Adjust the headlights. However the xenon self leveling headlight aim is just too low from the factory. You may have to use a screwdriver to remove the ring to access the adjustment screws.
It is not lowered. You will need 25 feet of room to back up. Point the headlight beams to a wall and verify that the headlight beams are as shown in the figure.
Adjust the vertical beam adjust the height of the beam by turning the top screw. Park the mazda 6 one foot away from a large wall or garage door. There are upper and lower bolts that attach the headlights to the front of the car simply by loosing or tightening either ones will change the angle in which they shine.
Pop the hood and locate the adjustment screws behind the headlight buckets.